Upholstery & Carpet Cleaning - Tool & Tutorial
- Procure These Things
- Print Templates & Prepare Blanks. A template for the vac nozzle, and one for the vac-tube/handle are combined in a single 8-1/2" X 11" PDF document.
- Drill, Cut, & Sand Vac Nozzle Blank. ...
- Drill & Cut Vac-Tube/Handle. ...
- Install Spray Nozzle Fitting, Tube, & Nozzle. ...
- Apply Vac Nozzle Seal. ...
- Drill Vac-Tube/Handle Hole. ...
Full Answer
How do I make my own carpet cleaning solution?
• 1 Gallon of Hot Water (using filtered cold water is fine if you have a carpet extractor with a built-in heater) • 1 Tablespoon of Dawn (or any other dish soap) • 5-6 drops of Lemon Essential Oil (optional, only for the fragrance) 1. First, fill hot water in the water tank of your carpet cleaning machine. The hotter the water is, the better.
How to use a carpet cleaning machine properly?
First, fill hot water in the water tank of your carpet cleaning machine. The hotter the water is, the better. Be cautious when handling the container filled with hot water. Remember to save some space in the tank for other ingredients.
How to clean a carpet with a scrub brush?
Dip the bristles of the scrub brush into the solution and rub them into the carpet. Massage them into the fibers well (without fully saturating the carpet) and follow up with a cloth to help blot excess moisture.
How much water do you put in a carpet cleaner?
• 1 Gallon of Hot Water (using filtered cold water is fine if you have a carpet extractor with a built-in heater) 1. First, fill hot water in the water tank of your carpet cleaning machine. The hotter the water is, the better.
How can I learn to clean carpets?
0:425:41CARPET CLEANING TRAINING VIDEO - YouTubeYouTubeStart of suggested clipEnd of suggested clipLooking at vacuuming. First a commercial upright back gets best results on carpets since the brushMoreLooking at vacuuming. First a commercial upright back gets best results on carpets since the brush unit opens the carpet pile and helps lift the dust particles. And removes the maximum amount of dirt.
How do you use a carpet cleaner step by step?
2:488:32How To Use A Rug Doctor Carpet Machine - Ace Hardware - YouTubeYouTubeStart of suggested clipEnd of suggested clipHere of the rug. Doctor. Don't worry about spilling a little bit of water because you're cleaningMoreHere of the rug. Doctor. Don't worry about spilling a little bit of water because you're cleaning the carpeting you're just going to extract it up so you want to hold this up carefully.
How do you clean carpet like a professional?
1:393:495 Tips To Clean Your Carpet Like A Pro - YouTubeYouTubeStart of suggested clipEnd of suggested clipDon't add any soaps or any sort of additives to this water you want this to rinse the carpet out notMoreDon't add any soaps or any sort of additives to this water you want this to rinse the carpet out not only the dirt and grime. But also the soap. So water only in there.
How do I deep clean my carpet myself?
Mix 1/4 cup salt, 1/4 cup borax and 1/4 cup vinegar, then apply this paste to deep stains or heavily soiled sections of carpet. Allow the paste to sit on the carpet for several hours until it dries completely, then vacuum it away.
Should you shampoo carpet until water is clear?
Do you keep cleaning the carpet until the water is clear? Yes, only when the water is clean, can you be sure that your carpet is thoroughly cleaned. To reduce this dirt, never walk on carpets with shoes you have worn on the street and clean with a vacuum cleaner at least once a week.
Are you supposed to rinse carpet after shampooing?
Detergent left in a carpet, serves as a magnet for new dirt. When finished shampooing, run a tank of clear water over the heavy cleaned areas (e.g. entrances and walkways). This will help remove excess shampoo and keep those areas cleaner for longer. It also helps to rinse out the shampoo from inside in the machine!
What happens if you don't clean your carpet?
This has a very simple explanation... when a carpet gets dirty, only the top third of the fibers are really getting dirty.
Can a bad carpet cleaner ruin your carpet?
I'm sure you've heard about Carpet Browning. That happens because the carpet cleaner didn't do the job the right way, and it could potentially ruin your carpet for ever.
How to keep carpet clean?
(The furs are likely to be more embedded.) Brush and groom your pet more frequently to help keep your carpets clean. Choosing high-performannce pet-friendly carpet for your home.
How to clean a rug that is too delicate to vacuum?
Start by rolling up the carpet indoors, and then unrolling it upside down in the snow.
How to get rid of a splotchy spot on a rug?
Let it sit for a few minutes, then vacuum it up. Next, blot the stain with 1 cup warm water mixed with 1 tablespoon vinegar working from the outside edges inward.
How to get snow off a rug?
Using your hands and a paddle, beat the rug so that the dirt falls downwards and is captured into the snow. Move the carpet again and repeat the process until the underlying snow is clean.
Can you use club soda on carpet?
You can use club soda if the stain is fresh to loosen it before it sets in, but also consider applying a carpet cleaner according to product guidelines. Always continue to blot at the stain and the cleanser, rather than scrub. Remove Carpet Stains.
Can you keep carpets clean without a vacuum?
Simply put, it’s possible to keep your carpets clean without bringing in heavy cleaning equipment. In a world where we have very high expectations of our vacuums and rent steam cleaners to handle the rest, it’s good to step back and remember that there are efficient ways to keep your carpet looking clean without the machinery.
Can you clean a rug without a vacuum?
Without a vacuum, you can still clean a rug with a stiff-bristled broom and a dustpan. This is an especially easy method of cleaning if you have a low-pile carpet. If you’re cleaning thicker, high-piled or shag carpets, be prepared with a little patience and sharp eye, because it’s easier for dirt to become embedded in the fibers.
Step 2: Print Templates & Prepare Blanks
A template for the vac nozzle, and one for the vac-tube/handle are combined in a single 8-1/2" X 11" PDF document. Using an inkjet/laser-jet printer, print the templates onto an 8-1/2" X 11" label sheet. Using scissors, cut out the two templates as shown in Fig. 1. Take care to keep the cuts straight along the lines.
Step 3: Drill, Cut, & Sand Vac Nozzle Blank
Clamp the PVC vac nozzle blank down to a rigid work surface, with the drill backer board underneath, as shown in Fig. 8.
Step 5: Install Spray Nozzle Fitting, Tube, & Nozzle
Feed the length of 1/4" clear vinyl tubing through the two 3/8" holes in the vac-tube/handle. Push the 1/4" hose barb to 1/8" FPT fitting onto one end of the vinyl tubing. Then push the barbed end into the 3/8" hole as shown in Fig. 19 and Fig. 20.
Step 6: Apply Vac Nozzle Seal
As shown in Fig. 21, cut and apply strips of 3/8" X 3/16" weather striping to the PVC vac nozzle plate.
Step 8: Mate the Vac Tube to the Vac Nozzle Plate
Place the PVC vac nozzle plate on the work surface with the screw pilot holes facing down. Measure and mark a center line from top to bottom with a pencil, as seen in the images.
Step 9: Fasten Vac Nozzle Plates Together
Align the acrylic vac nozzle plate with the PVC plate. Use the awl to punch pilot holes through the weather striping at all 7 plate mounting hole locations. Fasten the plates together with 7 #8 X 1/2" SS screws. Tighten the screws evenly until the weather striping compresses to approximately 1/8" thick. See Fig. 28.
Step 10: Modify Air Blow Gun
The air blow gun is being used as a water-spray trigger-valve for the hand tool. Remove the unneeded hanging hook by clamping the blow gun into a vise, then saw it off with a hacksaw as shown in Fig. 29. Take care not to cut into the outlet tube to avoid creating a leak. Use a file to smooth out the nub.
How do I clean a carpet cleaner?
1. First, fill hot water in the water tank of your carpet cleaning machine. The hotter the water is, the better. Be cautious when handling the container filled with hot water. Remember to save some space in the tank for other ingredients.
What is the best way to remove stains from carpet?
For all of us, this would be very easy to find. Just look inside your kitchen and grab that bottle of your aqueous solution. Yet, this condiment can’t beat that pesky stain alone.
What is the color of coffee in carpet?
One of the most burdensome stains that your carpet might obtain is coffee. Coffee stains make your carpet gross and filthy. The distinct yellowish-brown color of coffee stain can be disgracefully mistaken as your pet stool.
How do I get beer out of a carpet?
Go get one can of beer from your fridge, then drop a bit on the stained spot on your carpet. Beer does not work like magic because you need to rub the liquid into the surface of your carpet in a circular motion. If the stain still appears, repeat the process and never give up.
How to get rid of a stain on a rug?
• While the stain is still wet, counter it with little white wine to lessen the stain color.#N#• Pat the area with a sponge wet with cold water.#N#• Put some salt in the material then let it sit for 10 minutes.#N#• Vacuum the area.
Does carpet cleaner smell?
As there are no harmful chemicals, it leaves no bad smells after applying on the carpet . Unlike the chemical-containing products, it removes all the stains yet keeps the rug’s soft and smooth texture.
Can cornstarch be used to remove ink from carpet?
Best for ink stains. Cornstarch can erase that almost impossible to remove ink stain in your carpet, almost like magic! Ink applied on fabric is very nasty. There is a way that you can entirely remove it, and that is with the help of the powdery cornstarch hiding in your kitchen cabinet.
