Lift one corner of the carpet with a pair of pliers and gently tease it free of the tack strip (Photo 1). But be careful; it's easy to unravel the fibers. Then you'll be able to grab hold of the carpet and pull it away from all the tack strips like a zipper.
Full Answer
How do you Tuck carpeting in near walls?
Tuck carpeting in near walls with a tuck tool or carpet kicker to ensure your carpet stays flat and free of ripples. You'll also need tack strips to help you secure the backing as you use one of these tools. Carpet edges need to be waterproofed to prevent moisture from causing damage under your floor.
What tools do you use to install carpet?
share this article: Carpet installation tools are tools that allow people to install carpets on their own, without professional help. They include chalk, duct tape, gripper edge, hammer, knee kicker, masonry nails, power stretcher, saw, seaming iron, seaming tape, stair tool, staple gun, tackless strips and an utility knife.
How do you use a pull scraper on a carpet?
A pull scraper is the best tool for this job because it can reach close to the wall without causing any damage to the carpet. For this technique to be effective, it's important to do it before you get the carpet wet. Install the crevice tool on the end of your vacuum cleaner hose and vacuum the area you just scraped.
How do you reinstall carpet with tack strips?
When you're ready to reinstall the carpet, trim the pad so it rests right next to the tack strips and staple it every 3 in. or so along the seams and the tack strip (Photo 6). Mark the carpet at outside corners and cut angled clearance cuts with a utility knife.
How do you clean corners and edges of carpet?
Scrub the edges with a long, thin cleaning brush to dislodge the debris. Use a carpet edge cleaning brush, toothbrush, or grout cleaning brush to scrub the edges of the carpet. Work the brush into the carpet and scrub along the skirting boards. This will loosen dust and dirt that are lodged in the carpet.
How do you clean dark corners from carpet?
Here is how to deep clean the dirty carpet edges:Agitate the pile of carpet with a hard-bristle brush or a pull scraper.Place the crevice tool on your vacuum cleaner hose and run it along the affected area.Dip a clean white rag in warm water and vigorously scrub the black marks on the carpet.More items...•
How do you carpet around a corner?
0:383:09How To Cut Carpet At Corners - YouTubeYouTubeStart of suggested clipEnd of suggested clipCut that part out and then just go ahead and cut that else straight across drop it down beautiful.MoreCut that part out and then just go ahead and cut that else straight across drop it down beautiful. That's ready to be stretched let's try another one.
What equipment do professional carpet cleaners use?
The Professional Carpet Cleaning ToolkitVacuum Cleaner. A vacuum cleaner is one of the essential carpet cleaning tools your staff will need to complete cleaning jobs. ... Carpet Cleaner. Carpet cleaners remove deeply embedded dirt, bacteria, and stains. ... Defoamer. ... Stain Remover. ... Air Scrubber. ... Carpet Rake. ... Smartphone.
How do you clean dirty corners on floor?
How to Clean Dirty Kitchen Floor CornersSweep the entire kitchen floor. ... Combine 2 tablespoons white vinegar or ammonia with 1 quart water in a spray bottle. ... Scrub the corner with an old soft-bristled toothbrush. ... Rinse the corner with clear water and wipe dry with a rag.More items...
How do you vacuum corners?
2:175:58Vacuuming Carpet | Tips the Pros Use for the Cleanest Floor - YouTubeYouTubeStart of suggested clipEnd of suggested clipAlways behind you and never in your way in front of you as for vacuuming. Itself you want to startMoreAlways behind you and never in your way in front of you as for vacuuming. Itself you want to start in the corner. And first push the vacuum. Forward this pulls all of the fibers.
What kind of staple gun do you use for carpet?
Best Staple Gun for Carpets—WORKPRO Heavy-Duty Staple Gun Carpets are a breeze to fit using the WORKPRO heavy-duty staple gun which can effortlessly tackle many other jobs like upholstery and insulation too.
How do you square up a carpet?
6:098:21HOW TO SQUARE UP CARPET - YouTubeYouTubeStart of suggested clipEnd of suggested clipWon't take my chalk line now stick it in that loop right there and where I just cut it and the slip.MoreWon't take my chalk line now stick it in that loop right there and where I just cut it and the slip. And you'll really get an eye for how crooked it is after do this.
How do you install carpet in an odd shaped room?
2:373:55How To Carpet Odd Shaped Rooms - YouTubeYouTubeStart of suggested clipEnd of suggested clipNow we're gonna go ahead and fold that back rough. Cut everything in all. Right good to go let's getMoreNow we're gonna go ahead and fold that back rough. Cut everything in all. Right good to go let's get that seam tape on there boom boom boom. Burnin. The third seam.
What do commercial carpet cleaners use?
Hot Water Extraction Otherwise known as steam cleaning, this is easily the most common professional carpet cleaning technique. Steam cleaning uses hot water at high pressure to penetrate into carpet fibers, breaking down the dirt and bacteria stored deep within. The hot water is then extracted via vacuum.
How do you steam clean carpets like a professional?
0:381:51How To Steam Clean Carpet - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt's not like a vacuum. So remember to use long slow strokes. After we've soaked the carpet inMoreIt's not like a vacuum. So remember to use long slow strokes. After we've soaked the carpet in solution then we press back and we go over the same area. And we suck up all the dirt and moisture.
Which carpet cleaning method is best?
steam cleaningThe best method of cleaning carpets is usually steam cleaning, which removes over 90% of dirt and bacteria from carpeting. Dry cleaning carpeting is also effective for ensuring carpets are ready for foot traffic as quickly as possible.
Why does carpet get dark around the edges?
Why Do the Edges of Carpets Get Black? Those dark lines on your carpet around the baseboards and skirting boards are called filtration soiling or draught marks. They happen because your HVAC or ventilation system forces air into rooms faster than it can exit.
What causes dark spots in carpet?
When it comes to carpet and couch cleaning, these dark spots are caused by a combination of friction, and a buildup of dirt that is left behind by our shoes and boots. To put it simply, when you walk over a carpet or sit in the same area, your feet are rubbing against the same carpet fibres.
What causes carpet discoloration?
Discoloration is caused by accumulation of small particles that are present in the air of homes. Vacuuming or washing usually cannot remove discoloration. However, professional cleaning equipment with enzyme based agents has been shown to be effective at removal on some cases of carpet soiling.
How do you use prochem filter?
Prochem Filter-Out is ready to use, so no dilution is required. Apply directly to carpet fibers, saturating the soiled areas. Allow 3-5 minutes of dwell time to loosen soil. Agitate with a soft brush or groomer if needed.
How do I remove baseboards from carpet?
Scraper: Use a multi-purpose bar scraper to remove the baseboards and nails along with the carpet padding. Hammer: A claw hammer would be best for your DIY carpeting project to insert new nails and can help remove old ones. Knee pads: Protect your knees as you rip out the carpet and put all the staples from the floor.
What to wear when you remove carpet?
Gloves: Wear heavy-duty work gloves while you remove the carpet to protect your hands against nails and staples. Duct tape: You can wrap up the carpeting with duct tape after removing the panels from the floor. Spiral nails: These nails make the wood floor paneling sturdier because of their superior gripping power.
How to protect walls from carpet stretcher?
If you have it, you could use a piece of wood and some scrap carpeting to protect the wall from the carpet stretcher. Set the carpet at a 15-degree angle across the room to about half a foot away from the wall. If the power stretcher can't reach certain corners, use a knee kicker.
How do I get rid of glue under carpet?
Adhesive remover: Use adhesive remover to get rid of the glue under the carpet padding. Scraper: Use a multi-purpose bar scraper to remove ...
Do you have to remove carpet before you start working on the floor?
Check the baseboards: Old carpet usually isn't installed under this trim at the bottom of the wall, so you won't have to remove it before you start working on the floor. If, for some reason, you do have to rip out the baseboards, remove them with a flat pry bar.
How to clean a carpet with hydrogen peroxide?
A solution of equal parts of water and hydrogen peroxide is also an effective cleaner. Test your solution on an inconspicuous part of the carpet to make sure it won't affect the color or damage the baseboards . Work the cleaning solution into the carpet with a scrub brush.
What is a filtration line?
Sometimes called filtration lines, they also occur along the bottom edges of closed doors, and they can be difficult to remove. A vacuum may remove some of the discoloration, but the smallest particles are electrostatically bound to the carpet fibers.
Why use a white rag on carpet?
It's important to use a white rag to avoid transferring any dyes to the carpet. If the carpet is sufficiently clean after wiping, your job is done. If not, it's time to call in the cavalry.
Can you clean filtration soil on carpet?
It takes more than a vacuum to clean filtration soil on the edges of your carpet. Neglecting to change the filters in your home's central heating and cooling systems creates a problem that might, at first glance, seem unrelated to the filter. As air gets sucked through gaps in the floorboards and baseboards, tiny dust particles can get lodged in ...
How to stretch carpet against baseboard?
Stretch the carpet against the baseboard with the knee kicker and embed it into the tack strip. If it's too hard to stretch with the knee kicker, use the power carpet stretcher.
How to get carpet tighter after kicking?
Immediately after kicking, embed the carpet in the tack strip with your hand to hold it in place . With more or harder kicks, you can “ratchet” the carpet tighter.
How long are tack strips?
Tack strips always come in 4 ft. lengths and are available with concrete nails for slabs or standard nails for wooden floors, so be sure to get the right kind. Cut the strips to length with a tin snips (Photo 4).
What is the best tool to rent for carpet?
The most important tool to rent is a “power” carpet stretcher (Photo 8). It does the lion’s share of the carpet stretching.
How to get rid of a swollen knee?
Stretch any remaining tight areas with the knee kicker. Rest the teeth about 6 in. back from the wall or built-in and “kick” with the spot above your kneecap. Then embed the carpet with your hand.
What to do if you don't cut your carpet?
If you don't cut enough, make another pass in both directions. If the rental store doesn't rent carpet cutters, you'll have to make all of your cuts with a utility knife, working from the backside. Be careful and work slowly to keep your cut accurate. Get Dog & Cat Urine Out of Carpet.
How to take care of a squeaky floor?
If you have any pesky floor squeaks, this is the perfect time to take care of them. Walk around the room with a keen ear and mark the squeaks on the floor.
