What is a ninja warrior?
The Ninja Warrior is an electric powered carpet extractor intended for commercial use. This appliance applies a cleaning solution to the carpet and then vacuums the soiled water back into the recovery tank. Model: Date of Purchase: Serial Number: Dealer: Address: Phone Number: Sales Representative:
How to clean a Moto R?
1. Plug power cord from machine into properly grounded wall outlet. 2. Turn vacuum moto r switch on and off to make sure there is electrical power at machine. 3. Using a clean container, fill the solution tank with clean hot water. Do not use water over 130°F. Mix in a non-foaming cleaning concentrate for use in hot water extraction machines, following the manu- facture's instructions printed on container. 4. Connect priming hose to solution fitting on machine. Turn on pump and run for 30 seconds or until a steady flow of water is coming out of priming hose. Turn off pump and disconnect priming hose. 5. Connect vacuum hose to machine. Slide the swivel cuff over the outlet on the tank. 6. Connect the hose to your machine and wand. Pull back the knurled collar on the quick disconnect coupler and push onto the connection on the chassis. To avoid leaks, check to be that a positive connection was made.
How to clean a wand vacuum?
a. To check, hold the wand about one foot above the surface to be cleaned and open the wand valve. A full spray should be observed from the nozzle. b. If the nozzle is not showing a full spray pattern, adjust nozzle for proper pattern, clean, or replace nozzle. 2. Normally, chemical is applied on the push stroke of the wand when cleaning. Vacuuming is done on the pull stroke. For heavily soiled carpets the wand may be used in a scrubbing manner, applying chemical in both the push and pull stroke. 3. When cleaning, keep the working opening (wand mouth) flat on the surface being cleaned. Keep the wand moving when the valve is open. 4. The shutoff float inside the vacuum tank will impede the vacuum flow when the vacuum tank is full. When this occurs, empty the vacuum tank by opening the dump valve and dispose of the waste in a proper manner. 5. Once the vacuum tank has been emptied, you may once again proceed with cleaning
What to do if your washing machine is not working?
If the machine is not working properly, has been dropped, damaged, left outdoors, or dropped into water, return it to an authorized service center. Do notpull or carry machine by electric al cord, use as a handle, close a door on cord, or pull cord around sharp edges or corners. Do notrun machine over cord.
When to unplug a washing machine?
Do notleave the machine unattended. Unplug machine from outlet when not in use and before mainte- nance or service.
Can a machine cause fire?
Machine can cause a firewhen operating near flammable vapors or materials. Do not operate this machine near flammable fluids, dust or vapors.
Can you run solution through a machine with the heater turned off?
The solution fittings on the machine will become extremely hot during operation. Allow sufficient time to cool, or run solution through the machine with the heater turned off before disconnecting or performing any maintenance on the heater.
